The field coil pole shoes are what need to be magnetized for the generator to start to charge.
For an A type system, in a two brush generator, the A terminal is connected to both the insulated brush and one end of the field coil. The other end of the field coil is connected to the F terminal. In a three brush generator the field coil is connected to this extra brush instead of the A terminal and then the F terminal like a two brush unit.
When you apply battery voltage to the A terminal in an A circuit type generator to polarize it, the current flows from the A terminal through the field coil, back out through the F terminal and is then grounded inside the regulator by the normally closed field relay. In the case of a three brush generator the current must also pass through the windings of the armature to get to the third brush before entering the field coil. In both types there is also current passing though the armature to ground but that has no affect on polarizing the pole shoes.
In a B circuit type system you still need to polarize the pole shoes but the only connection between the A terminal and the field coil is that they share a common ground inside the generator. Energizing the A terminal will not cause any current flow through the field coils since it will merely end at the common ground connection. In order to have the necessary current flow though the field coil to magnetize the pole shoes there must be battery voltage applied the the F terminal. The F terminal relay in the regulator is in an open position so there will be no voltage applied to the field coil by applying voltage to the A terminal of the regulator.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
