Posted by Billy NY on July 03, 2012 at 12:41:57 from (67.248.100.3):
In Reply to: storage shed posted by rat0851 on July 03, 2012 at 12:01:48:
At short glance, you may be referring to lumber treated with the newer ACQ or a non CCA treatment, which is what you want(CCA) for a ground contact post. I don't have the technical information, but apparently the newer treatment, reacts with galvanized fasteners, (going from memory, could be wrong) you have to use fasteners compatible with the lumber and or its treatment. Do some research on the web, there has been discussions in the past here on CCA, AQ, ACQ wood preservative, you can likely find it by searching.
Concrete and posts, modern designs use precast or poured in place footings and then gravel around post bases, the concern is decay at the top of concrete where the post comes out, traps water etc.
There are other designs and materials if you like, perma columns ( look those up ) and similar that keep the posts out of the ground.
If you still want to go with a conventional pole barn, by all means source CCA treated 6x6's .60 if you can, its available for ag use, was banned for residential use some years back.
Erecting posts can be done a variey of ways, I did these by myself, 18'-0" posts 5'-0" into the ground, they were old CCA posts, sat unused for years, I soaked the ends in creosote and set them using a choker of the backhoe bucket, string level on a stringline for alignment and marked all the posts so I could set them for elevation, set them all without help, but wish I did have an extra hand, would not do that again, but when you have a free backhoe, you do what you must LOL !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
