YOU HAVE A FLOAT POSITION on the lever/valve you have. You use this when you use a single hose on a single acting cylinder. IF you would put the lever linkage in the correct hole (in the picture item# 3 or 9. Put the rod in the TOP hole and you then have a detented float) it would go past the power down position into a detented float position. This would be pulling the lever back/down. This will drop the haybine faster and it is the correct way to use a single acting cylinder on a JD 4010.
You can use it like you are but it is hard on the hydraulic system and it also will not go down very fast. Also you have a valve leaking internally is why it is picking the haybine back up. By using the float you maybe able to keep using the valve without fixing the bad valve!!!!!!
You are talking about a 1960 JD 4010 that is a six cylinder tractor???? IF you have a small JD 4010 compact tractor than forget everything I told you
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
