ii should have worded this different , im not looking for a 1 pass tool, what ive been doing is discing a couple passes until the disc is axle deep, then using a 6 foot landscape rake making a couple of passes, to break up as much as possible, then i use a home made harrow, which is made about 12 feet wide, with 1 inch rebar welded to the bottom of 90 lb railroad track every 3 inches to finish, i lift the disc out when i turn, but the thing is just old, not sure how old as we bought it at a auction many years ago but i figure 50's 60's or so, what i would like to make is a tool that has closer spacing than a disc does to make the primary passes, im also wondering about using rock crusher screen about 1 inch or 1 1/2 inch which i have access to at work welding it into a roller to roll behind the harrow to break up the clods even finer,but i still have some clods around 3 to 4 inches, they will break up if it rains, but it doesn't rain here anymore it seems , just wondering if anybody has built something like that , looking for ideas ect,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.