Posted by Royse on June 18, 2012 at 20:03:42 from (69.36.49.151):
In Reply to: Painting posted by old on June 18, 2012 at 06:33:10:
Your local auto parts store should have push on clips that will work.
I'm with showcrop on the paint.
If you're painting a show tractor, that's another story, but if you just want to make it look decent go with the off the shelf enamel.
It's a one step process, you paint it and you're done.
Heck, you can brush it on if you want to it will still look better and help prevent rust. My hand isn't steady enough to brush paint!
The base coat/clear coat stuff I paint cars with is no where near as neat and forgiving. Go look at your brand new car/truck in the sun, the paint texture from the factory will look like an orange peel.
If you have bare metal, prime it. If you have loose paint, take it off and then prime it. If you paint over it the old paint will continue to peel and take the new paint with it.
Wish I could still buy laquer paint and do all that wonderful wet sanding.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.