Posted by JOB on June 16, 2012 at 06:08:37 from (173.84.196.130):
Years ago I had a 76 Monte Carlo That had #5 spark plug fouled with oil. The modulator valve on the transmission eventually went bad and caused the engine to suck transmission fluid through the intake manifold. It sucked so much oil that the engine gained oil in the crankcase.It took me awhile to find out what was causing the engine to smoke as bad as it did. I replaced the modulator valve.
The next time I changed spark plugs #5 plug was clean as a whistle.
What I plan on doing and if you folks with older engines think this would benefit you could do it. And if you engine men think this is a mistake let me know.
On an engine I have there are pipe taping's on the intake manifold. I was going to plum in a line with transmission oil and a valve so the flow could be regulated. Start the engine on gas then open the valve until the engine smokes pretty good. Run it that way for several times and hope it cleans any sticking piston rings, oil or compression.
What do you think is this foolish or will it do some good?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
