Posted by Retired Farmer on June 07, 2012 at 10:50:19 from (207.200.116.74):
In Reply to: I can do better posted by flying belgian on June 06, 2012 at 19:38:32:
I think I see what you are talking about now, just came back from the monthly junk sale at the local sale barn and there were three old New Holland balers there. I looked at the knives on the knotters on all three of them. The knives are rivited on the stripper arm instead of being screwed on. You can take the stripper arm off and sharpen the knife if it is dull or if you replace it you will have to cut the rivits off and replace them. The knives have nothing to do with the length of the tail. There is a spring on the side of the Twine Tension Disc that you either tighten or loosen to change the length of the tail. Should be a nut on a stud. Turn it about one eight of a turn at a time and then bale and check the length of the tail. It doesn't take much to change it a lot. Hope this helps you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.