Posted by ericlb on June 05, 2012 at 05:37:51 from (70.41.96.39):
In Reply to: safety stands posted by Gene-WI on June 04, 2012 at 17:29:37:
i use 2 different kinds depending on what i need them for, i have a nice extra heavy duty set of the ratcheting kind for working on vehicles, these are much beter than the pin thru the hole kind, also i made a set of screw up kind, kind of like a super size set of what people use on rv's i use these mainly to support the rear of trailers when loading and unloading tractors ect so the weight shift doesnt jerk the rear axle of the pickup up off the ground [ had a bad wreck some years ago this way, it was the dogs doing, but i was lucky to survive it,] one thing about this, when loading leave a inch to a inch and a half of space on the stands or you'll be anchored right there , grounded against the stands
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.