Topper, not sure what the UK translation is, but must be a 3 pt mounted implement.
I quick hitch would be ideal for some, but I've never had too much trouble hooking up 3 pt implements without help.
Make sure the lift arms have enough swing or free play beyond the width of the lift pins on the implement, adjust turnbuckles or limit chains and or whatever you may have on your DB. I try and set the height close, a little lower, and tray to center so the lift arms push in and and I can lift onto or align the lift pins. You can target one, put a lynch pin in, then hold one brake and let the tractor turn into the other, close the gap and or hinge over to the opposite pin, now each to their own, usually, with enough play in those arms, you back in straight, and only use the brake if one side is not close enough. I'm sure preferences vary, but I never have help, the one thing I do forget it some implements the pto shaft is best hooked or lined up and close before attaching lift arms, I forget which tractor and implement, but I have done that and not had enough clearance to hook the pto shaft on, unless I hooked into it first, then backed up, and set the arms. Obviously do not back or go to far forward if its locked on the pto shaft, don't want to bend it or something. There have been time where I have connected one lift arm and pushed back on the implement to get it to line up, as well as reaching down, and setting them from the seat, problem is its kinda too far to stretch, foot comes off the clutch, you are stretched out leaning over, you could get tossed off with a running tractor in gear, not really a good idea, to do that unless maybe you had a tool that would reach the lift arm(s) to set them, and if its that bad, best to have that 2nd person around, or that quick hitch if you can use one of the many being offered out there today.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
