Posted by MFan on May 29, 2012 at 07:12:23 from (192.43.65.245):
I recently rebuilt a Bobcat 371 skid steer and have found the rims were very loose after minimal use.
Originally the rims were held on to hubs using wheel bolts, but the threaded holes in hubs were worn enough that I went with bolts through the hubs and lug nuts. However, it appears that the rims don't have a deep enough "dimple" around the lug holes to let the cone of the lug nut center and hold the rims tightly.
The rims were new with the rebuild, and now one has had the lug holes reamed bad enough to need replacement. I'm thinking of welding the bolt heads on the back side of hubs enough to hold tight (and prevent backing out) and going with lock washers and nuts (and Loctite) to get more clamping power around rim hole.
Sorry for the long post. Any thoughts or similar experience?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.