Posted by jfharper on May 26, 2012 at 10:24:38 from (173.255.107.35):
Given the price of hydraulic fluid now a days, I'm thinking its better to fix my leaks then keep buying fluid.
In my rear valve for the 3 pt rams on my mf 205 industrial, there are fitting holes (female) that are 1/2" that have fittings going into them that are 1/2" NPT tapered thread going to female 1/"4 NPT swivel that seal by I think that mechanical seat...the 1/4" hose as an inside bevel.
The questions is, if the female holes on the valve that have the fitting (1/2" NPT tapered thread) cranked into are producing leaks (which they are) could I buy the o-ring boss or o-ring boss face seal fitting which have straight threads thus fixing the leaks with the o-ring instead of the tapered thread cranked down? Are the female holes tapered too or just the fitting that goes into it? Anyone know of these old valves?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.