Posted by mike henry on May 22, 2012 at 18:40:40 from (75.21.162.146):
BiL has a MF 50 that he is offering to me. $600. This is what is known wrong. 1 rear wheel and tire 24x14.9. Wheel is rusted pretty bad around the valve stem. Possible weld up? Next and more importantly is the lever that attivates the 3 point has a lever just under the plate that most times shifts to a degree and the system wont activate.Can that be a serious problem or an easy fix. I am new to this breed. Runs good shifts good, sheet metal is good, little paint but not much needs to be done. What do you all suggest I look at closely. Are there any achile heals for this tractor? I am looking for a shorter wide front for my wife to drive on tractor rides. It has to go 10 mph at least to keep up. Anyone got suggestions I would appreciate them.Thank you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.