Have you measured corner-to-corner? It's just another way to check to see how much out of square it is. Check your measurements with a friend helping just to double check, if you haven't already done that. If it is out of square as much as I think it is judging by your measurements, I'd be very-very unhappy with them. That building shouldn't have more than a half inch difference in sidewall length. It should really be exactly the same. If you care enough about this building to spend the money pouring a crete floor you should have a square building. If you put in a ceiling it will be crooked, for instance. If you want to divide it into rooms someday in the future the rooms will be crooked. Last winter I remodeled a 50 year-old cattle shed, dividing it into two rooms, lining the walls and putting in a ceiling. This cattle shed was built by two people, an old carpenter and a rookie helper. The building was perfectly square. The steel ceiling sheets fit like a glove. That's the way yours should be. I hope this company is good to deal with because they just might have to tear it down and rebuild it for you. Let us know how it turns out. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.