Bret4207 said: (quoted from post at 07:30:13 05/08/12) Zeb, looks like your left bottom is shallower than your right. Gotta level it out.
in this picture it was most definitely NOT level or pulling centered behind the tractor I made some more adjustments but I am still having problems with the forward bottom cutting in to deep causing the rear tractor wheels to spin.
thanks ,
-Paul
For Bill,
I have read Faulkner's work and understand it....However there have been many other books written in the last 69 years that make the case for plowing being disc, chisel or moldboard as a means of tillage. I understand all those too.
but that leads me to the reality of working with what I have which is 50 year conventional till equipment. Add to that the fact I have not decided on weather or not to certify this particular field organic lead me to moldboard this field and leave the sprayer in the shed.
and then there is the learning aspect for some one who did not grow up farming to actually see how different equipment works the ground
This post was edited by FarmerZeb at 17:08:26 05/08/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.