Posted by JDseller on May 02, 2012 at 02:49:56 from (208.126.196.144):
In Reply to: Float Position posted by foxhoun on May 02, 2012 at 02:27:38:
There are four valves inside each SCV on a JD 4230. There is a pressure and return in each direction on each SCV. Yours has a internal leak from the high pressure side to the low when it is in the float position. Also on JD system when the SCV is in float the ports still have transmission pump pressure on them. That is 135-170 psi. I see guys just push the control to float to unhook the hoses. There is still enough pressure to make them harder to unhook.
Your valve could just need the valve re-adjusted but it is more likely that they need rebuilt. Which could just be a oring seal kit or all four valves could be bad. IF it is just a replace the orings and re-adjust then it is not too high a repair. IF you need the valves they are around a $100 each. So if you need all three plus the overhaul seal kit you are in the $400-500 range just for parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.