I inspect mine periodically, from the 90 deg turn above the wood stove and the horizontal through the concrete wall to the base of the flue, which is 8"x12" adjacent to a 24" x 24" flue for the fireplace upstairs. I have another one of those large flues, 24" x 24" and another 8" x 12" for the oil fired furnace. Furnace one gets swept as needed, furnace is serviced annually, late model, efficient, not much soot. Those large fireplace flues never got any creosote build up over the years when in use. I mostly use the stove now and every time I inspect it, there is no creosote build up at all, in effect I don't have much to clean, what little there is flakes off over the summer, and I clean the base of the flue out, maybe a coffee can full of soot.
Dry wood, keeping the flue temperature hot enough, seems to do it, even when I had wood with moisture, not green, but not as dry as I wanted, never any trouble either, now I'm able to get that wood done on time so moisture will not be an issue. I have hot cycled it, usually not by choice, that dry wood, and its oak, maple, black cherry, elm, buckthorn, apple etc., small diameter stuff will take off, sounds like a blast furnace, draft is excellent, pipe will get red hot, so when starting a fire, I do not load too much, this old Ashley 25-HFR , throws heat instantly.
If I had smaller flues, through combustible wall penetrations, I'd probably inspect monthly, I have a clean out on the horizontal above the stove, just pull the cap of, shine some light, can inspect any time, does give you some "peace of mind" and know there are no problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.