I've worked on alot of different brand rotary screw compressors and as far as I have seen they are all pressure lubed. In fact they usually have a minimum pressure valve on the discharge side of the reciever/seperator chamber that maintains, usually, around 80 psi of pressure in the system, for lubrication purposes, even if your load draws more CFM than the compressor puts out. In other words the answer to your question is yes, the cooler is under full system pressure.
As far as repairing one of the coolers I've never had it done myself so I can't say with 100% certainty one way or the other on that. However I will say that most of them I've run into are steel due to the pressures involved and as such are not usually repairable, at least not by anyone I know aout, if the leaks are in the areas I believe you are meaning the are.
With all of that said, what brand and model compressor are you working on? I know where a few older ones are setting, and I run across one on occasion here and there, so if I know what to look for I just might know or be able to find what your needing.
Worst case scenerio take a look at the link. I've never done business with this place but I found them awhile back when looking for a cooler to go on a hydraulic system that had an abnormally high backpressure on the return system to the point that 'standard' coolers wouldn't work. The customer wound up selling the machine before anything was done but I kept link for future refferebce. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.