Posted by Fixerupper on April 15, 2012 at 18:46:35 from (100.42.82.164):
You truck mechanics probably know all about this already but my son and I are still in the learning stages when it comes to newer truck electronics.
Son just bought a 05 9200 International truck to pull the feed trailer with. It has an IXM Cummins ( I think, it's the new M11, if that's what it is)and everything is electronic. It already had the switches on the dash for the PTO and the air hose going to where the PTO should be so he thought it'd be an easy job to switch the PTO and wet kit from the old truck to this one. He changed it over just fine, but when the PTO is engaged and he's unloading feed the engine acts like it gives up and bogs down. And if he pushes in on the clutch to make a small position adjustment, the PTO is programmed to kick out. So after a call to a mechanic he found out the PTO 'switch' needs to be turned on in the truck's computer or ECM.
Stopped at his favorite IH dealer, they put their laptop on it, but they couldn't get through to the ECM. Next day he went to a truck shop that specializes in IH and they found out the old GPS connections were still plugged in. The GPS connections were unplugged, he got into the ECM and found out it needs a PASSWORD, GRRR. He's gonna call the dealer he bought it from (150 miles away) to see if he can get some information. If not, it's a 150 mile trip to Sioux Falls, and a day's lost income, to have the computer flashed and re-programmed. Gone are the good old days when we could just crank a screw. After wrenching on many new computerized combines, Im a true believer that more hours are lost on newer machines due to electrical/computer problems than hours lost on mechanical failures. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
