Posted by JMOR on April 14, 2012 at 19:31:20 from (72.190.9.193):
In Reply to: 2 cycle gas-oil mix posted by Dennis Dorsey on April 14, 2012 at 06:27:49:
Bendee said: (quoted from post at 22:16:10 04/14/12) Why don't you stick to the 16:1 and if shrouded in a cloud of smoke, raise it to 20:1 up, up, until you are satisfied. In the meantime save your money.
Do you really know if the modern oils are better for the machine.
All have overlooked the engineering design changes that may provide for a better scavenging of the oil & routing to bearings (differing bearings) than in the past............it isn't at all just better lubricants!
For me, I go with the original manufacturer recommendations, not some "current day" opinion or oil salesman's rec.
Still use 3/4 of a pint in 1 gallon in my 1960 Homelite, just like it says on the tank cap (10:1) and after 50 years it still cuts the wood! Good luck to those who cut the mfgrs rec!
This post was edited by JMOR at 06:49:11 04/15/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.