Grinding ends of valve stems for lash/clearance when doing valves and seats was a known procedure for Tecumseh and Briggs small engines- also done on Harley side valve restorations, Ford Flat heads and some overhead valve engines like some jeeps and Continental tractor engines. The problem of minimal lash on many of the small engines sort of started for many in mid 1970s when unleaded gas became requirement and valve seat erosion became worse. BMW motorcycles /2,/5,/6 series designed for leaded gas had a rally demonstration display at Dells rally 1980s with examples of badly eroded valves. The 4000 mile adjustment schedule was reduced to 2000 miles and some people had filed end of valve stems to get proper clearance just to make it through end of riding season. Check for valve seat material- the old iron seats that were good for leaded gas need a harder seat now for unleaded- look for Stellite seats or something similar- couple other names out there indicating higher nickle and chrome content, might be called stainless steel seats. Ford N tractors supposed to have used Stellite seats some from factory, Onan might have a LP gas valve seat spec number available. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.