Both the legal scrap yards here need a picture I.D and your SSN before they'll buy your stuff. If you sell them enough scrap to go over a threshold amount they report what they have paid you to the IRS and the comrades in Madison so they can be sure to collect their taxes. Maybe we're going about this wrong if you find out what scrap yard the stuff ended up in AND can ID the seller turn them into the IRS, the Sheriff will be the least of their problems at that point. Trafficking in stolen goods is still a crime if you can locate the stuff in a scrap yard turn the scrap yard in AND sue them for damages, they'll end up making it right with you and sing like a bird on their "vendors" or you end up owning a scrap yard- cool eh? One of our local HVAC/refrigerator repair services had some aluminum condensers stolen from their shop, the owner of the HVAC firm didn't know they were gone until he saw them at the scrap yard when he was dropping some other stuff off. The scrap yard was more than cooperative in fingering the thief and willingly assisted the D.A. with the prosecution. There are still a few Mom & Pop scrap dealers out their that may be a little shy on ethics and by design or ignorance don't have the best record keeping but with the environmental regulations and IRS attention a lot of them are run by business men with to much money invested to traffic in stolen goods or not have adequate records that'll stand up to IRS scrutiny. I guess their might be some good from the nanny state.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
