It was one of those projects where if I would have stayed on it at the time, I co9uld have had it finished in a matter of a couple hours of my time. Then it sat, I forget why, and things rusted up a little more. At the time Dad couldn't find a rebuilt one anywhere, so he had to spring for the brand new vacume pump.
That added to the postponement because I always figured if they got a good 7-10 years out of a rebuild, a new one surely would last longer than that. So far it has, but then Dad mentioned it a couple months ago and asked what it'd take to finish it up "just in case". I got a start on it in early January. I brought it in to work and cleaned everything up a little better in the parts washer, and then decided that the bore was looking pretty bad so I found an engine shop with a big enough hone to hone it out. (they get lots of 2 pops too). The new bearings felt rough that I had pressed in the side plates, so I took them out and then blanchard ground the side plates to get rid of the grooves that were wore into them, and then installed new bearings.
A little time welding up the bearing journals and turning them back down, cleaning up the vanes and some reassembly, and now it really sucks!! Still gotta come up with the QD taper lock bushing for it because the old one is lost, but that shouldn't be too hard once I figure out the size it needs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
