Posted by Doug - Iowa on March 24, 2012 at 18:16:15 from (208.126.0.19):
In Reply to: Simple amp meter posted by Doug - Iowa on March 22, 2012 at 19:02:09:
Thanks guys. I'm fully aware of the dangers of a CT. What I am really looking for is monitoring the load on my big saw. I typically just clamp my Fluke meter on the line and leave the cover off the panel. If I set it just right I can see the readout from the saw table. When its just me in the shop that's no big deal, but with others coming by (grandkids) I'd like that panel closed up.
I can buy a cheapo clamp meter at HF and wire a loop of the saw circuit out of the panel to hang it on. No big deal. I just thought it would be interesting to make one that measured the whole shop. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.