Posted by Christos on March 14, 2012 at 08:46:27 from (64.134.171.162):
I took the advice that Jerry/MT suggested and I went back through the points/condenser. After a few tries I got her set at the .22 the manual calls for with my feeler gauge.
Installed everything and it fired up, fired up really well. The throttle worked perfectly fine as well and the tractor cut out on me after I hit 2000RPM after a few seconds.
Restarted the tractor and it likes to misfire through the air cleaner like it did before I replaced the spark plugs with the correct gap.
Jerry/MT suggested I jump the key switch to determine if it was bad. How do I do that safely?
I am planning on another post today showing how much fuel is coming out the carburetor bowl/fuel line at the inlet elbow later today when I get back home.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.