This is my humble observation. Notice how the engine was originally designed to allow for hank cranking, though, it was never cranked started since it was on that tractor, as the engine doesn't stretch far enough forward unless you have a very long crank. Notice the front member suspension. There is not even a slight arc in it. I figure that it came from a car built early. My guess is that except for the engine most of the tractor was originally a car or small truck. Notice the gas pedal and single brake pedal instead of two brakes and a hand throttle. I also notice that the outer pedal in pic #2, which appears to activate the brake, appears to be fabricated. The face looks factory, yet, the arm looks like it was welded on. The reason I don't think that the engine came from a tractor is that I figure the frame of that tractor would have been used. I remember that when I was slightly younger, there were agricultural power plants like that. They were used to power all sorts of things, such as sawmills etc. My best guess is that the engine is likely one such power plant. I have a feeling that the transmission is shifted on the colum though the clutch is pretty beefy, Perhaps a twin disc, look at pic #2 & #5. In short, I think the transmission, driveline and suspension are from a truck. The engine was likely a stationary power plant. There are a bunch of acc. from the truck, or atleast car. It appears tied to gather with locally fabricated parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
