Posted by dave2 on February 27, 2012 at 07:59:16 from (139.139.35.69):
Wish I'd had a camera with me... This thing looked like a receiver hitch BUT.... The receiver tube went forward and stopped right before the axle, was made out of 1/4" or thicker (?) steel, and was about 4"x6"... Then came the slide in part for the ball mount all slid in and "bolted" in place, with a 2" ball like the one in the pic (silver part) bolted on with 2 of what may have been 5/8" diameter bolts.
Guy was all proud of it and showing it off... Said it was what made him pick this truck over another one that just had the little 2" receiver :roll:
He pulls a fiberglass 2 horse trailer with it......
I'd tell y'all where he got the truck from, but I don't want my favorite Texan to get em in a wad again. Fraid he's gonna get diaper rash and be cranky :shock:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.