TX Jim you are right that this cover lets you look at the transmission gears. I wanted to see the ring and pinion as well. Plus I have stands and a lift made to remove the rock shaft housing while holding the cab up. I can have the rock shaft housing out in less than an hour. Then you have much more room to look at the transmission/rear end. I really wanted to see as much as I could since there had been no filter or screen in the transmission. So I removed both.
I also removed the transmission charge pump this morning. It is shot. I am really trying to get the guy to just take his lumps and sell this money pit. You would have to take every single hydraulic component off and clean/rebuild them. Plus with the engine problems and AC issues, you would have the whole tractor stripped to the frame/block/housings. With planting 35-45 days away and three other tractors already here needing work, I am not sure I could get it repaired correctly in time for him to use it this spring.
How are getting the parts catalog pages to copy to here??? I use jdparts and can get them to copy to my computer and print out but they will not post to this site. It keeps saying file not found when I try to up load it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.