The rod is in great shape, the rod seals have just started seeping to the point they will leave a stain when parked. Thing is the guy needs them fixed since he operates in alot of hard surface areas like parking lots, and on alot of residential properties where grass has already been planted. Unfortunately the only way to change the seals is to remove the piston to get the head off. Funny the piston seals is still in great shape and is giving absolutely no trouble at all, as has been the case in 95% of the other cylinders I've built on equipment in the 20 year old or newer range. Rememeber when they used V packing on the rods and if you had a leak all you had to do was remove a few shims to tighten it up or, worst case, remove the old stuff and cut the new stuff diagonally and put it in with the cuts staggered like a set of piston rings? I've seen machines with the V packing that gets run everyday and they seem to get better life out of them than any of the new stuff. Again, those were the days.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
