Four or eight breakers to supply out buildings from the utility pole without installing an additional breaker panel. Plus a place to connect a standby generator without back feeding with a "farmer fix" . 30Amp 120/240V to each out building would be a minimum. Install one of those little 30amp 4 or 6 circuit pony panels in each outbuilding. May seem like lots of power now but sooner or later you will be glad to have it. Always best in each out building to have lights and lights only on their own breaker(s). The other receptacle/load circuits on other breaker(s)separate from the lights. Or if you don't want to install a panel at each out building. At least run 2x20amp 120/240V from the yard panel to two separate 20 amp T-slot gfi receptacles at each out building. One pair of gfi's to plug lights into. The other GFI to plug tools into. Running three wires is minimum. Run four wires and have twice the power at each out building than when using three wires.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.