Posted by Tx Jim on February 16, 2012 at 03:40:17 from (67.142.163.22):
In Reply to: 401B john Deere posted by barnE on February 14, 2012 at 09:03:29:
JDseller said: (quoted from post at 03:04:07 02/16/12)
You are right in that it usually is the orings/backup rings around the control valves that are the most common three point leak.
My MAIN idea in my posting was to get Ken to make sure his pump was the cause of his problems. You and I can argue all day about the fine details of each other's postings. You see break downs in TX that I don't see here. I have repairs that you don't see there.
As far as the AT21781 thermostatic control valve. I must not be the only one needing them. John Deere still has them in the warehouse and you can still buy one. If they never sold one then they would drop the part.
Also the "thermostatic control valve" is just a pressure relief valve. Temperature will not open it unless you have the lift piston clear full of hydraulic oil and heat makes the oil expand therefore building pressure.
As far as JD stocking a AT21781 valve that is no indicator it's a fast moving or regular selling part. JD stocks 2 cyl parts that I'll bet aren't daily sellers. I never indicated no valves were sold as I replaced some as a cautionary thing so as not to have to "re-lick the calve" JD named the valve thermostatic not me. And yes heat can cause it to open hence I guess it's JD NAME. They're are several dairies in Tx that feed large sq's of Alfalfa. I've got a large dairy just 3 miles from me.
Finally I totally agree it's much better to diagnose the hyd system that throw high $$$ pumps at it.
This post was edited by Tx Jim at 03:41:52 02/16/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
