I doubt that very many 3 foot trees were "chopped down". The only chopping done was to cut out the top of the notch which determined the felling direction. The rest was done with two man crosscut saws that were so sharp that they would give most chainsaws a run for the money. Add to that the dormant state of the tree in early winter, frozen wood and nice cold air to work in and the speed at which forests could be logged off was amazing. As far as firewood was concerned, in a lot of cases the smaller limbs not being suitable for lumber were stacked up and cut up for firewood later in a number of ways. Usually with a hand bucksaw back in the 1800s but in later years with tractor or stationary engine powered bucksaws and a gang of men. I have been there and done all of the above. My brother and I still talk about it. Sawmills were located nearby so as to make for short hauls. Lumber was "rough sawn" and then either used that way or hauled by sled or wagon teams to a planing mill to make finished lumber.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
