Posted by Glenn Warner on February 12, 2012 at 19:32:12 from (64.80.179.153):
Anyone on here remember the Grudge match pull between a steam engine and Dick Wyffels 1800 Oliver tractor.It was back in the mid 60's. I didn't see it personally but heard about it .If memory serves me right ,it was at one of the earliest "pagents of steam" shows.The owner of the steam engine made his brags from a cold start noone could out pull his machine.Dick challenged him. they haggled out the bet where the steam engine owner put up his steam engine and Dick put up $5000.00 cash. Winner had to pull the other machine 20'.Dick after about 15 minute had moved (by jerking)the steam engine to about 19' at which point the steam engine was only at about 2/3 steam and the owner opened the valve . Needless to say the steam engine never spun a wheel, just all traction ,and Dick took his Oliver home but was poorer for his efforts .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.