Posted by John T on February 11, 2012 at 07:30:27 from (66.87.2.81):
In Reply to: John T??? posted by Kirk Grau on February 11, 2012 at 06:52:53:
Kirk, as an electrical power distribution design engineer with that logical systematic orderly way of approaching problems I had considered it way back in my twenties and thirties. HOWEVER it was when I had to take an early out engineering retirement (but still with a good pension and health insurance for life) in my early foties it became more of an opportunity as a semi retirement income option. There were some other motivations of being in business and having been ripped off and screwed over a few times that made it even more desirable lol SOOOOOOOOO I bit the bullett and did it some part time while still working. Id work 8 hours then drive 75 miles to night classes then study and work it was tough about killed me Id NEVER do it again. The time and hourssssssssss of reading cases was really hard but I made it and passed the bar the first time
So it tough but its been a rewarding semi retirement career, I pick and choose what cases I take and have a very limited small home country law practice which I enjoy in the summer months. We winter in Florida and go west every year or so in the RV LIFE IS GOOD
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.