Man, do I know how hard it is to find a GOOD used spreader. After I started into the beef business, I discovered the need for a spreader. It was getting kind of deep around here. So I found an old NI pto spreader a neighbor had and bought it. It was OK for a year or so until part of the frame rusted off and one wheel kind of started sagging and dragging. So I borrowed a little IH from a neighbor to finish up with that year. Then I found a big JD that had been on a dairy farm for $500. It had a logging chain setup for the feed apron and lasted for several years with little maintenance. But one day as I was going oout across a field with a load on, I got to wondering why the beater seemed to be missing. It was still there, but kind of skimming the grass tops. The frame had rotted through and allowed the whole back end of the machine to kind of sag past the axles. Didn't do a great job of spreding, either. Then I bought a nice looking tandem NI. It broke the rear table shaft just outside the gearbox after the first year. Seems manure had rusted it nearly through, and it didn't last long. Trying to get the old shaft out of the gear in a ress was more than it could handle and a new gear and shaft was almost twice the cost of what I paid for the spreader. So, it was off to the auctions, where I found a really nice lookin Oliver for $300. Beaters looked good, the boards looked great, tires looked usable and the frame didn't appear to be rusted all over. At last- a creampuff. Loaded it up halfway and tried it out. Not a problem. So, i put a full load on it, started to spread and went about 100' when the feed chain broke. This spreder had been taken care of. But it had also been used. Almost every link was close to paper thin and may have been ok for stall straw, but not for pen packed manure. I finally brole down and bought a new one. I take care of it, and it's lasted about fifteen years now, and is still near new. But look at EVERYTHING on one before you buy one. It may look real nice, but S--- happens, and not many are real good after a few years on the farm.
Remember, these are the toughest machines on the farm- they kick the crap out of themselves--
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
