Posted by Keith Williams on January 23, 2012 at 03:45:30 from (24.142.137.35):
In Reply to: Gleaner K Combine posted by carolina plowboy on January 22, 2012 at 18:22:41:
Carolina Plowboy, First thing you need to do is get the manuals for the machine. Operator manual will give you the know how to get you started AND to understand why the adjustments are necessary. With that said, You need to have 3 pulleys and belts to do corn, beans and wheat. 8 inch for high speed for small grain (Wheat Oats). 11? inch for beans. 20 inch for corn. Gives you 3 speed ranges. Then you adjust the speed in that range to get the best job. You will change the speed as the crop changes during the day. I used the channel concave bars for wheat in positions 1 3 5. One half rounds in beans in 1 and 3. Same in corn, but sometimes added #5. I believe I used the filler bars in corn. Here are my notes for Wheat My notes from the past with my K are as follows Sheave 8" Concaves # 1,3,5 Channel bar Concave Clearence 3/8" Chaffer 3/8" Sieve 5/16" Cyl Speed 7-10 Try 8 to start Wind 5-10 cranks in (I use belt level with edge of pulley)
I normally use the cyl speed to adjust for the dry of the day. 9 or 10 early in day or close to dark. 7 or 8 in middle of the day. If set too high the Wheat will crack.
For a good source of info try the following web site. http://www.harvesting.com/combine/gleaner/ Keith
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.