Posted by Wesley Stephens on January 21, 2012 at 21:36:53 from (75.252.81.193):
In Reply to: expressions posted by flying belgian on January 21, 2012 at 21:03:02:
In this area of NC (southeast) people who are stuck are "bogged down." In the northeast part of the state, they are "mired up." Also, harvesting tobacco here is called cropping (which can apply to collards and other things you remove a few leaves off of at the time from the bottom up) but they call it priming in the northeast. When you go west to the mountains, they speak much differently than we do. My father in law was from Murphy, the farthest west town in the state, and their speech is very, very different from the eastern half. I don't know about other states, but in NC you can tell where someone is from in the state as soon as you hear them talk (except for areas like Raleigh or Charlotte with a lot of influence from transplants) and sometimes the difference will be less than 30 or 40 miles, though it can cover a large stretch, depending on the region.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.