Between Dad and I have about 22 seasons burning wood in outdoor boiler in North Central Minnesota conditions. Average 10 cords/loose volume on truck 8 cords stacked tight (4'X4'x8') per location a winter. I heat 36x36 shop/12foot ceilings, and newer 1600 square foot house. He heats 24x26 shop 50deg. constantly and 2200 square foot older home. I also heat enough hot water to keep 4 kids, wife and myself in laundry and baths. You can burn just about any wood you chose but remember BTU content is key, If your going to saw and split 10 cords you might as well get most bang for the effort. I've seen many installations that were done poorly cost owner of these furnaces dearly in wood. Going cheap and shoddy on water line insulation my uncle and cousin with smaller houses, near myself burn 18-20 cords/year and grow beautiful January lawns above their water lines. My Dad's had excellent luck with mild steel construction and Central Boiler from Greenbush , MN his unit went 18 seasons without a leak. Mine is a Heatmor I bought rusted out and rebuilt the firebox. So far 4 years and no trouble + I only paid 100.00 for the unit. All in all not a bad way to heat if you have wood available and the time to fill 2x day. Smoke at start up is considerable but short lived with seasoned wood and like was said above carefull placement accounting for wind conditions is also important. Efficientcy is another matter, I think all manufacturers ratings are over stated and there is waste out the flue no matter what they claim. I figure no mess, no insurance hassle, no fire hazzards, hot domestic water and unlimited wood supply works for me. It may not for others good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
