Sounds like you did it the right way. Actually any driveway should be crowned so the water drains readily away from the traveled surface. If the driveway has a noticeable grade it's even more important to prevent water from washing down or across the surface. Ditches on the sides are neccessary to carry the water away unless the driveway is somewhat elevated above the surface of the surrounding area. And, wherever these ditches "bottom out" there should be an escape drain of some sort to carry the accumulated water away. In some situations this may require a buried crosstube (culvert) to convey the water from the highside ditch of the driveway to the lower side where the water escapes away to prevent it from accumulating in the ditch on the highside and eventually puddling in, and then then washing across, the driveway surface to the lower side. Giving serious thought and basic engineering practice to driveway location and design can be essential to keep them from being a continous problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.