Tempered glass can not be cut - Period. The way normal glass is made is that it is cooled down very slowly and evenly. This allows the glass to shrink uniformly while cooling. Tempered glass is cooled quickly. Because of the amount of mass there, the edges cool first and solidify. Then as the inside cools it wants to shrink but can't since the outside of the glass piece has solidified. The inside then is pulling on the inside and ends up under tension. If any part of the sheet weakens, the entire piece is able to release the internal tension and shatters into the 1/4" pieces we all love.
If you untemper the glass by reheating it (Usually while floating on a pool of mercury) and then cool it slowly the glass can be cut just like normal glass. It must then be retempered.
Laminated glass is 2 pieces of normal glass with either a mesh grid work or plastic sheet in between. This can be cut normally but is a bit more difficult because of the inside layer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.