Stephen, Thanks for the post, gotta love this enjoyable sparky chat.....Your experience is certainly appreciated, at least by those of us who are sparkies lol
You say
"Really the outlet having two sets of screws is what its made for, to string one to another."
Im NOT agreeing or disagreeing or arguing but with all due respect to educate some here who may not be aware (electricians and engineers will most likely and maybe you also) of this procedure, PLEASE BE ADVISED
Theres yet ANOTHER POSSIBLE REASON for those two sets of screws!!!!!!!!!! ITS SO YOU CAN BREAK OFF THE TIE/JOIN TAB AND FEED THE TWO (of a duplex receptacle) FROM INDIVIDUAL BREAKERS/CIRCUITS Such is whats referred to as a "multi wire branch circuit".
How it works is you can use just a single Neutral (GrounDED conductor) and two hot phase wires L1 & L2 so the top outlet is on one 20 amp circuit (one of the 2 screws) and the other bottom outlet (the other of the 2 screws) is on another 20 amp circuit yet one Neutral can suffice for BOTH. The 2 branch circuits are fed with a two pole circuit breaker with tied handles so if one is off both are. There are reasons for and aganst this but Im not going to go there now, Im not wanting to sTART a fight or argument, just to educate some who may not be aware of this particular reason and method of having two not just one screw.
NOTE this was NOT my usual method of specifying, I didnt use many multi wire branch circuits, theres a time and place for them. I have already voiced my preference opinion of wiring and others have done likewise, this post is NOT about any of that or tended to re hash it or whats best, the poster has made his choice which I respect regardless if it agrees with my method or not. THIS WAS TO EDUCATE ANOTHER POSSIBLE REASON EXISTS FOR HAVING TWO SCREWS.
God Bless yall, keep safe, were headed to see Annie with the son whose comin home for Christmas from San Diego and the Daughter form Austin TX woooooooo hoooooooooo
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
