Posted by John T on December 06, 2011 at 06:58:35 from (173.243.181.15):
Okay, lookin for good reasons why and why not. I inherited the "preventive maintenance" gene and usually do it and never had a problem thereafter. Some say if it aint broke dont fix it, but Ive often violated that rule lol
When I have a vehicle with an auto tranny and even thought it shifts PERFECT, somewhere around 100,000 miles I get this uncontrollable urge to have the tranny fluid power flushed (supposedly that changes the torque converter also??, mechanic buddy has huge expensive Snap On or other brand of power AT flusher) and refilled and change the filter also, and nowadays I refill with Synthetic Fluid. IVE NEVER HAD ONE GO BAD AFTER THAT. Ive also considerd hanging a magnet on but never have.
NOTE Im my RV or trucks I also add a big honkin external tranny fluid cooler, I think they help big time if youre pulling something.
ANY GOOD REASONS WHY I SHOULD STOP THE PRACTICE???? Ive heard some say never change it is why Im asking
John T Just a Preventive Maintenance Kinda Guy (Heck I may run out and change the air in my tires, that nasty stale air in there is gettin old lol lol)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
