Posted by LOU from Wi. on December 06, 2011 at 01:14:01 from (174.124.34.175):
Yep I Know J.S.I.U, and open the wallet! Now a problem that some of us runs into. Trying to find information on products so we might be able to use a different manufactures part in lue of original .I purchased a walther ppk 380 and want to put on a laser rear sight. Needed to know the width of a glock beaver tail opening so we could have a rear sight laser pressed in. Called the Laser-lite co. and was told it was a trade secret and wouldn't release such information.Found a gunsmith that had the information we needed, so with a micrometer the ppk was a bit narrower in width then the glock which is about the thickness of a playing card. The reason for the rear sight laser is because We are going to change grips from plastic to Rosewood with thumb depression. Beautiful grips. Other wise the laser site would have to be in the plastic grip replacement.Cutting back the rear laser site would be the answer rather then re-grooving the slide assembly on the ppk 380.I can't see where there would be a danger in releasing such specks. That information on trade secrets would be, If I was to manufacture a slide assembly to be sold to any person for the same purpose as I have in mind.Installing a rear laser sight on a ppk 380.No one makes a side grip laser in rose wood. I Know J.S.I.U, and blame Laser-lite for with holding information that can be had by any reputable gun smith.We have E.Mailed most everybody we could think of including S/W, walther, other gum manufactures and no reply. Any one have similar problems? Done ranting. now. LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.