Ray My observation of your post meant you only had a gun, at your side posing no direct threat to the other guy.. It was only there to prove you would protect your self if he brandished a weapon to stop you from using it.
Long time ago I was hunting about 100 yards off an old side road sitting waiting for a drive to come through ( My guys were doing the drive and sent me around the hill in a vehicle to bring them back) So I had a loaded gun watching for deer to come through I noticed a pickup parked near my car and he loaded up his gun it was cold and he was only in a warm vest with the orange vest, and hat. he walked directly to me with the rifle (at ready, but at waist level sideways to me), and told me I was trespassing, and I had to leave. seems like I was about 200 yards inside his line he had posted , and he was nice about it I apologized, started to leave when he said . "it's Ok for this one time.just to finish the drive out,but not to come back" he turned around went to his truck and unloaded his gun, and left. I never felt threatened as he was only protecting what was his , but if he would have directly pointed it at me... I would have felt it to be excessive force.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.