Posted by Nofbdybs on November 27, 2011 at 13:43:33 from (74.249.134.114):
Got a problem with my air compressor.
Its a Speedaire 5hp, 80gal, 3phase horizontal.
Anyhow, it is something that is in the pressure switch.
Here is the entire assy.
When the pressure exceeds 100psi, this problem begins.
This is the problem part, the little part that is connected to the hard line.
This little "device" is some type of valve. There is a little needle that extends from the tip of the "nipple" It connects to the hard line above it.
Anyhow, there is a small paddle assembly inside the switch that moves against the little needle. As the needle is pushed in, it will bleed air. (why?)
Under normal operation, the needle will extend all the way out, close the valve, and will not leak air.
I cant make it stop leaking. There is a constiant hissssss coming from that little device. Not a major loss of volume, but enough to deplete the entire tank in just a few hours.
My question is this. Is that little valve bad, or is there something in the pressure switch that can be adjusted to get to to close fully?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.