Ford's were normally parent bore engines unless they had repair sleeves installed.... and some did come that way from the factory. If there's no coolant in the bottom end then the block is probably fine. Get it running and see if it's pushing coolant out the overflow. Look for pressure against the rad cap, bubbles in the rad or plain old black froth in the rad. That would suggest to me that it's got a bad head gasket which is not an entirely uncommon thing with them. It's about a 200 buck fix if you do the labor yourself. Usually it's just a new gasket... and I like to lap the valves and install all new upper gaskets and check the injectors while they're out... Also make sure to chase the head bolt holes with a bottoming tap and clean them good and check the head for flatness with a machinist' straight edge. It may need planing; it may not. After rereading your post... I'd say it IS a head gasket problem. Just check it out for bubbles when it's running. Does it puke coolant under load?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
