Posted by Bret4207 on November 22, 2011 at 05:32:04 from (64.19.90.196):
In Reply to: Singleshot 22 posted by Scott in SF on November 19, 2011 at 14:14:01:
With all due respect, the Savage 24 does not have a "weak chamber" because of the ejector. With the action closed a properly fitted ejector has very little clearance and any split rim gases will be deflected tot he side by that massive standing breech.
Yes, a split rim can happen with any gun and any RF ammo, but with a properly chambered rifle in good repair the gas will be deflected to the side by the breech block or bolt. I'll bet dollars to doughnuts your old RB was a take down, had a worn breech block screw and that it didn't have correct headspace. I'm sorry you got injured, that part of the reason we're al supposed to be wearing safety glasses when ever we shoot any gun or work with any tool. But there is no more danger from a properly set up RB or falling block or rocking block RF action that's in good condition than there is from a $2500.00 Cooper bolt gun. OTH, take any rifle that's been abused or worn a bit and add in some less than trustworthy ammo and you have the makings for an accident.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.