Posted by Paul from MI on November 04, 2011 at 14:49:22 from (204.106.241.145):
In Reply to: Re: OT generator posted by buickanddeere on November 04, 2011 at 13:38:43:
I worked for many years in a plant with 240 volt three phase systems. In one building we had an old 240 volt delta system, with no mid-point tap for 120 volt. We used step down single phase transformers to create 120 volts. Essentially they were 1:1 transformers, with a center tap on the secondary for 120 volts, single phase. The other building had a "Red-leg delta" system, which was a 240 volt, 4 wire, three phase delta system where the center point of one phase was tapped to provide 240/120 volt single phase power. These are not uncommon systems in industry where 120 volt loads are low compared to three phase loads. The 208/120 three phase wye systems are usually used in applications where 120 volt loads are relatively higher, although we used that system in on are with a high concentration of Japanese machines which were 200 volt three phase. The 208/120 system kept the three phase voltage within 10% of nominal for those machines and avoided step down transformers. It was also within 10% of our American 240 volt three phase machine, so it worked well for us. Just a thought.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
