Posted by Leon in Mn. on October 28, 2011 at 17:03:48 from (75.221.42.59):
In Reply to: NOT a good idea... posted by Bob on October 27, 2011 at 09:07:21:
I disagree. Bob is ABSOLUTELY RIGHT. I have used aftermarket switches with both the accessory position and ignition positions being seperate while using the 10SI alternators, and had no problems with it at all. If hooked to (a) seperate accessory position it kills power to the alternator while also seperating the power feedback to the switch (which would feed the coil circuit) to keep the engine from not shutting off on a gas tractor. It has worked fine for many years on tractors that I have owned. You also need to know that not all switches work the same. Some switches the accessory and ignition switch are "hooked together" in the switch and may not really "disconnect" from themselves once off. In this case they will feed back. I use a switch from NAPA which uses 2 accessory positions with the ignition position. You should test them before using them. You DO NOT need a light to run this alternator. My 2 cents Leon in Mn.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
