Posted by Bob Huntress on October 26, 2011 at 21:27:33 from (74.177.56.107):
As most of you know, I've been a military mechanic until I retired the first of this month. My son, whom I do love, has been less than impressive with his decisions. He may be on track, finally. Even though I have been a sea service man(first 9.5 with the Navy and since 2000 in the USCG), I can respect those who serve in the Army. This week my wife and I had enough. Her brother is 57 and still lives off his mommy. My wife's first marriage ended because her ex husband could never understand the idea that as an adult there were responsibilities, so you know she has to be concerned that doing nothing and living off us could actually be his long term plan. Today I took him to the National Guard recruiter. He goes to Memphis on Tuesday for the MEPS. I was a little surprised when he told the recruiter that he wanted to be infantry, and I talked him out of that. I told him that with all the fields that the Army uses, he had to want something more like a regular skill, afterall if you're in the Army, everyone is a rifleman. It looks like he will be taking Wheel & Track. I say congrats on the first decision that hasn't been stupid on his part, which is to say that if this works out for him, I'll be very proud of him. He knows that his unit is slated to deploy in 2013 for Afghanistan, and the recruiter had to tell him that until he completes Boot Camp & AIT he can't request a deployment with a unit going sooner. I remember after the Gulf War when I wanted to get right back on another float, but that was Navy and I was single(Overseas girls loved American sailors), but that will change after he's done a bunch of deployments. I'm pretty glad about how this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.