Posted by patsdeere on October 25, 2011 at 20:33:45 from (69.181.81.254):
In Reply to: Possible seized engine? posted by Scott L Maxfield on October 25, 2011 at 20:30:19:
You could pull the pan to see where the crank is and if it is horizontal you could take a block of wood and persuade the pistons to go down (starting at one end and working back and forth). That should get it free. You could also put your favorite rust penetrator in there and then put it in high gear and rock it. Or pull the pan and unbolt the rods and pound on the pistons until they give and then push them out the top so you can rehone the sleeves.
I would probably try it in the rock in gear method first, then blocks of wood and finally pull pistons. Since it has been shedded it hopefully won't be too bad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.